Authors' views are not necessarily those of the IAC. Main website at www.theiac.org.uk. Note: this site uses harmless cookies. https://dialog.theiac.org.uk/dialog/
Last part (3) of the Elmo GS 1200 Xenon restoration project
Last part (3) of the Elmo GS 1200 Xenon restoration project
Posted: Thu Nov 29, 2012 11:19 pm
by Desmond Godwin
For anyone out there that was following my restoration of the Elmo GS1200 Xenon its now completed and you can watch the final part(3) below.
Thanks. Desmond
Re: Last part (3) of the Elmo GS 1200 Xenon restoration proj
Posted: Fri Nov 30, 2012 10:14 am
by tom hardwick
Fascinating. But I was rather surprised that the hubs of the feed and take-up spools didn't scratch that soft emulsion in the extended scratch test.
Re: Last part (3) of the Elmo GS 1200 Xenon restoration proj
Posted: Fri Nov 30, 2012 4:12 pm
by Desmond Godwin
Tom thanks for comment. In relation to the take-up spools you may notice that the two of them are clear plastic types. They have 2 hubs with the outer one being compleatly smooth and that is why i used these for the testing. There is also a lot of slack on the loop but no scratches showed on the monitor after that extended time. Desmond
Desmond